Speedway Engineering's Grand National Aluminum Hubs

Grand National Aluminum Hubs

A very popular short track front and rear hub combination for late models or where aluminum hubs are allowed. The rand National Aluminum Hubs are strong, light weight, durable, and dependable. These come with the same heavy-duty bearings as the steel hubs. You can count on them for maximum performance every time you race.
Our Extreme duty rear hubs are specially designed for heavier vehicles with higher side loads.

Features:
> High quality, heat treated billet aluminum
> Black anodized to resist corrosion
> Standard with seal retaining rings
> Standard with rotor adapter mount
> A wide variety of dust cap/wheel starts available
> Assemblies come with Timken bearings

Benefit:
> Rotor adapters fit all popular rotor bolt circles
> Available in three bolt circles: - 5 x 5" - 5 X 4-3/4" - 5 x 5-1/2"

Grand National Aluminum Front Hubs		Part#
	Front Hub Only - fits Stock Car Products spindle (GN only)	5306
	Front Hub Assembly fits Stock Car Products spindle (GN only)	5306-10-1*

Note: Front hub kits include: Hub, studs, races, bearings, seal, brake rotor adaptor, dust cap, spindle nut, washer & hardware. Note: Bare hubs include races and studs. * Specify 8 x 7" or 8 x 7-5/8" brake rotor adaptors.

Grand National Aluminum Rear Hubs		Part#
	Rear Hub Assembly - fits Speedway Engineering, Stock Car Products, etc. GN housings	6001-10 LorR
	Rear Hub Only - fits Speedway Engineering, Stock Car Products, etc. GN housings	6001A

Note: Rear hub kits include: Hub, drive plate, studs, races, bearings, seals, brake rotor adaptor, dust cap, lock nut, washer, o-ring, and bolts. Note: Bare hubs include races and studs. * Specify 8 x 7" or 8 x 7-5/8" brake rotor adaptors.

Extreme Duty Grand National Aluminum Rear Hubs		Part#
	Rear Hub Assembly with aluminum driveplate- fits Speedway Engineering, Stock Car Products, etc. GN housings	6001A-HC-10
	Rear Hub Assembly With steel driveplate- fits Speedway Engineering, Stock Car Products, etc. GN housings	6001A-HC-11
	Rear Hub Only - fits Speedway Engineering, Stock Car Products, etc. GN housings	6001-HC

Note: Rear hub kits include: Hub, drive plate, studs, races, bearings, seals, dust cap, lock nut, washer, o-ring, and bolts. Note: Bare hubs include races and studs. Note: This hub does not use a rotor adaptor.